How to make D.I.Y. honeycomb floating wall shelves
First up, you should assemble the larger unit. Screw the top shelf onto the side panel, making sure the shelf support holes are facing inwards and that you have the white laminated edges facing the front.
Screw the rest of the shelves into place, and also attach the kick board using the pre-drilled holes at the base.
Make sure the back panel sits flush at the top and is parallel at the sides. Check that the white side is facing into the unit. Tap the supplied nails in around the edges.
Fold out the drawers and slide the bottom panel into the slots in the draws. Make sure the white side is on the inside of the drawer. Swing the front panel around and insert the dowels into the predrilled holes. You can use glue in the edges and dowels for extra support.
Slide the handle into the slot at the front of the drawer. Then screw it in from the inside of the drawer, through the pre-drilled holes.
Place the drawer runners over the pre-drilled holes on the bottom of the drawer. Then use your hammer to tap them into position.
Now install the drawer runners for the inside of the unit. Place them over the pre-drilled holes at the bottom and screw them in either side.
Take your drawer, line up the drawer's runners with the unit, and slide in your drawer. Then assemble the rest of your drawers (See steps 7-9) and slide them into the unit.
Now it's time to put the smaller unit together, which is exactly the same process for the larger unit (See steps 1-6).
Finally, assemble the smaller drawers (See steps 7-9) and insert them into the smaller unit.