Skip to main content
Bunnings

Sign in or sign up

No Bunnings account? Sign up
PowerPass customer?
Visit the dedicated trade website

Project list

Sign in to your account

Ready to Collect in 2 hours

How to sand timber floors

Timber floors.

Overview

You can give an old timber floor a big facelift by sanding it down. We show you how to use sanding machines the professionals use to get the job done. We also give you a few helpful tips on using sandpaper.

Steps

1Prepare to sand the floorboards

Start by making sure your floor is ready for sanding. Check every nail is sitting below the surface, to avoid the sandpaper catching and ripping. Any nails sitting above the timber should be knocked in with a hammer and a nail punch.
A person using a nail punch and hammer on a hardwood floor

2Install a sandpaper belt on the drum of the sander

Lay the drum sander on its side. Lift up the cover of the drum and slide the paper on. Sometimes the sandpaper can be a bit tight and hard to install. If that happens, wipe a little bit of fine sawdust on the inside of the belt to help the belt to slide on. If your floor needs a lot of sanding, start with a rough, 40-grit paper. For a floor in better condition, a lighter 60- or 80-grit is better. Use a finer, 120-grit for the second pass.
A person fitting a sanding belt to a floor sander

3Sand the floor with a drum sander

Make sure the drumhead is sitting off the floor, then pull back the lever that drops the drumhead onto the surface of the floor. To achieve the best results, push the drum sander forward along the grain of the floorboards, one row at a time. Move at a gradual, even pace to ensure the sander creates an even finish. At the end of each row push the lever down to lift the drum off the floor. Then reposition the sander to the next row and start again.
A floor sander on a hardwood floor

4Sand the edges of the floor with an edging sander

Use an edging sander to get closer to the skirting boards where the drum sander can't reach. Because these sanders use a disc that sands across the grain, you'll need a finer grit paper than the one you used on the drum sander.

A hardwood floor before being sanded

5Sand the tight corners with a detail sander

Detail sanders are great for sanding in tight corners, under kitchen cabinets and inside cupboards. They reach in where the other, more powerful sanders can't. Once again, for the best results, move the sander with an even and gradual motion.
A hardwood floor after being sanded

6Ready to seal your floor?

Check out our video on how to seal timber floors.
Health & Safety

Please make sure you use all equipment appropriately and safely when following the advice in these D.I.Y. videos. You need to be familiar with how to use equipment safely and follow the instructions that came with the equipment. If you are unsure, you may feel it is safest to consult an expert, such as the manufacturer or an expert Bunnings Team Member.

Grave health hazards are linked to asbestos, which may be in homes built up to 1990. Health hazards may result from exposure to lead-based paints in older materials and copper chromium arsenic (CCA) treated timber. For information on the dangers of asbestos, lead-based paint and CCA treated timber and tips for dealing with these materials contact your local council's Environmental Health Officer. You can also use a simple test kit from Bunnings to indicate the presence of lead-based paint.