Skip to main content
Bunnings

Sign in or sign up

No Bunnings account? Sign up
PowerPass customer?
Visit the dedicated trade website

Project list

Sign in to your account

Ready to Collect in 2 hours

How to grout wall tiles

A sponge being used to spread grout into gaps between tiles on a wet wall

Overview

Putting grout between your wall tiles fills in any gaps, helps keep them clean and gives you a smooth professional look. With a little know how, you can do it yourself. In just a few steps, we'll show you how to mix the grout, apply it to the tiles and clean up after. Grout comes in a wide-range of colours, so choose one that best suits your décor.

Steps

1Mix the grout

Put on your gloves and safety gear. Pour a small amount of water into the clean bucket and add some grout powder. Mix until it has an even consistency, about the same as toothpaste. If it is too runny, add more grout powder, if it's too thick add a little more water.  To find out more watch our How to mix grout video.

Grout being mixed in a bucket with a trowel

2Lay down some drops sheets

Protect your floor from splatters by laying drop sheets on them and use masking tape to keep them secure. Then remove any spacers between the tiles before you start.

Painters tape being used to cover the floor before a wall is grouted

3Apply the grout onto the tiles

Dip your grout float into the mixture and spread a generous amount onto the tiles. Use the float to make sure that every joint is full of grout. Always try to grout diagonally across the tiles, so the mixture goes into the gaps. Run the flat edge of the float across the tiles to remove the excess grout. Keep applying the grout until the mixture in the joint starts to set.

Grout being applied to tiles on a wet wall

4Wipe off the excess grout

Wet your sponge and wring out all of the excess water. Wipe diagonally across the tiles, until you have a nice clean joint that is full of grout. Repeat the grout and wiping off excess grout processes until all the tiles have grout between them. Once the grout is completely dry, put on your safety gear and buff the tiles and grout with a soft cloth.

A sponge being used to spread grout into gaps between tiles on a wet wall

Suggested products

Health & Safety

Please make sure you use all equipment appropriately and safely when following the advice in these D.I.Y. videos. You need to be familiar with how to use equipment safely and follow the instructions that came with the equipment. If you are unsure, you may feel it is safest to consult an expert, such as the manufacturer or an expert Bunnings Team Member.

Grave health hazards are linked to asbestos, which may be in homes built up to 1990. Health hazards may result from exposure to lead-based paints in older materials and copper chromium arsenic (CCA) treated timber. For information on the dangers of asbestos, lead-based paint and CCA treated timber and tips for dealing with these materials contact your local council's Environmental Health Officer.