Feast Watson Stain & Varnish Liming White gives a soft, milky white effect to timber and preserves the stain by protecting it with a durable clear finish. The water-based formula is non yellowing, and imparts colour without obscuring the natural characteristics of the timber grain. One coat gives a subtle, pale colour; multiple coats will build opacity and whiteness. Available in satin.


PREPARATION

New Timber
How to prepare New Timber:
Sand to a smooth surface and remove all sanding dust before coating.
TIP: Achieve that super-smooth finish (or if the timber grain is open or coarse) by applying a coat of Feast Watson Sanding Sealer and sand back as per the label instructions.
For naturally oily timbers, seal the timber with Feast Watson Proofseal as per the label instructions before application.

Previously Coated Timber:
How to prepare Previously Coated Timber:
Previously varnished surfaces need to be sanded to a dull finish. Remember to remove all sanding dust before coating!


APPLICATION

Make sure you love your colour! Using an off-cut or on an inconspicuous area, test the colour to ensure you are happy with your choice.
Ensure the Stain and Varnish Liming White is thoroughly stirred through before starting (and during!). Avoid introducing any bubbles!
Let's do this:

Apply Stain & Varnish Liming White using a brush or roller.
- If applying by roller, use a short nap (5mm) mohair roller. Ensure edges and end grain are fully coated.

How to apply Stain and Varnish Liming White to new timber:
If applying by spray, three coats are required.
Three coats are required, if you have achieved your colour after one or two coats, Just complete the following coats with a water-based interior clear coating as additional coats of Stain & Varnish Liming White will intensify the colour.
Provide 2 hours of drying time between coats.
Remember to sand lightly between coats with a fine sandpaper to get the best results.
If applying over a previous varnish coating, two coats will be sufficient.


MAINTENANCE

Keep an eye on the surface for any signs of colour loss or surface defects.
When required, lightly sand the surface, and remember to remove all dust.
Recoat with an additional coat of Clear Varnish as per application instructions.