Skip to main content
Logo - Bunnings Warehouse Festive - 2024

Sign in or sign up

No Bunnings account? Sign up
PowerPass customer?
Visit the dedicated trade website

Project list

Sign in to your account

Ready to Collect in 2 hours

How to install a laminate benchtop

A tape measure and pencil being used to mark a piece of particle board

Overview

There are only a few steps involved in installing a laminate benchtop. We'll show you how to join the different sections together and secure the whole bench to your cabinets. You will also see what tools you need, and get a few simple tips to help you get the best finish.

Steps

1Mark up where the sections of the bench will be joined together

Lay the bench sections in place on top of the cabinets. Crawl in under the bench and mark where the bench sections join. Then flip your benches and match up the marks again. Now measure and mark out your drill points. These are outlined in the instructions. 
A tape measure and pencil being used to mark a piece of particle board

2Make the holes for the benchtop joiners

Use the Forstner bit to drill holes in the underside of the benchtop. Mark the Forstner bit with a piece of tape so you don't drill the hole too deep. Once the holes have been drilled, use a handsaw to cut trenches from the holes to the edge of the benchtop.
A Bunnings team member drilling into particle board

3Prepare the cabinet attachments for the benchtop

The bench is attached to your kitchen cabinets using screws and brackets. Install the brackets into the top centre of the back panel of each cabinet. Then drill guide holes into the horizontal braces on the front of each cabinet. You'll use these later to screw up into the underside of the bench.
A piece of wood being drilled into a wall

4Join the bench sections together

This step of the video shows you how to use the bench joiner bolts correctly. The two sides of the bolt tighten together to bring the bench together. Place the sections of bench the right way up on the cabinets. Apply glue to the section joints and install the bench joiner bolts. Then pre-drill screw holes, up through the cabinets, into the benchtop and secure the benchtop in place with screws.
Two pieces of benchtop being secured together from below
Health & Safety

Please make sure you use all equipment appropriately and safely when following the advice in these D.I.Y. videos. You need to be familiar with how to use equipment safely and follow the instructions that came with the equipment. If you are unsure, you may feel it is safest to consult an expert, such as the manufacturer or an expert Bunnings Team Member.

Grave health hazards are linked to asbestos, which may be in homes built up to 1990. Health hazards may result from exposure to lead-based paints in older materials and copper chromium arsenic (CCA) treated timber. For information on the dangers of asbestos, lead-based paint and CCA treated timber and tips for dealing with these materials contact your local council's Environmental Health Officer. You can also use a simple test kit from Bunnings to indicate the presence of lead-based paint.