Feast Watson 4L Timber Floor Oil

Achieve that sophisticated, subtle matte finish to your interior timber with the Feast Watson Timber Floor Oil. Feast Watson Timber Floor Oil contains the perfect consistency to deeply nourish your timber, and is resistant to water and spills - the perfect penetrating oil for wood floors and match for your interior rooms. Achieve your Timber Floor Oil finish quickly and easily, with the option to burnish or wax your floor if desired, and regular maintenance coats can be applied easily without sanding. Feast Watson Timber Floor Oil is a natural floor oil that is the low maintenance, high-end look you have dreamed of. Preparation - How to prepare Feast Watson Timber Floor Oil: Let's get that matte look… Note: If you wanted to stain your timber, it is recommended to seal the soft porous timber with one coat of Timber Floor Oil prior to staining. To stain the timber, use a blend of Timber Floor Oil and Prooftint (up to 10%). New Timber - How to prepare new or bare timber/cork: Punch exposed nails below the surface. If you have any holes and imperfections, they should be filled with timber putty after the first coat of Timber Floor Oil. This ensures to match the putty colour with the coated timber colour. Sand timber to an even, smooth surface. Remember to vacuum and wipe to remove dust. Previously Coated Timber How to prepare previously coated surfaces: Clean surface with Feast Watson Floor Clean and allow to dry. If you have previous polyurethane coatings or varnishes, this needs to be removed by sanding the surface back to bare timber. If you have previous coatings of Timber Floor Oil, this can be recoated without resanding. Application - How to apply Feast Watson Timber Floor Oil: Let's start applying... Ensure your surface is dry and free from all dirt, dust, grease, wax, polish and oil. Begin by stirring Timber Floor Oil well before and during application with a flat blade stirrer. Be careful to introduce any bubbles. Apply a generous coat of Timber Floor Oil to the timber with a brush, roller, cloth or Feast Watson Floor Finish Applicator. Make sure your surface is completely covered - don't want to miss a spot. Go read a book and leave Timber Floor Oil to soak into timber for approximately 60 minutes. Wipe off any excess product with a clean cloth. First coat is dry? Great - move on to applying a second coat. You only need two coats of Timber Floor Oil. Allow 24 hours before buffing. Note: When applying Timber Floor Oil to floors, buff the floor after the final coat using a buffing machine (300 revs/minute). You're done. Good job. Do you need to stain your timber? Great - read this before applying Timber Floor Oil - Stain bare timber after sanding using Feast Watson Prooftint as per the application instructions. Apply one coat of Timber Floor Oil to seal soft porous timbers such as pine. This ensures your timber will absorb the stain and ensure maximum results! Ready to stain? Mix Prooftint with Feast Watson Prooftint Colour Reducer to allow time to evenly work the stain across the floor. Make sure you love your colour! Test the colour mix on off-cuts of flooring to ensure you have the right colour. Apply your stain to the floor with a Floor Finish Applicator as per Prooftint instructions. Make sure you allow 12 hours to dry before applying Timber Floor Oil. Maintenance - How to maintain my floor with Feast Watson Timber Floor Oil: Let's keep your floor looking its best... Make sure you allow Timber Floor Oil to cure for a minimum of 4 weeks before polishing. Regularly clean using Floor Clean. When the floor requires an additional coat, clean with Floor Clean and apply one additional coat of Timber Floor Oil as per instructions.