How to set up post supports for a carport

andrew
View the video

How to set up post supports for a carport

View the video
×

Project Overview

The first thing you need to do when building a carport is create the supports. Follow this step-by-step guide and we’ll show you how to mark out and install them yourself.

Continue to step-by-step instructions

Step by Step Instructions

1 Dig holes for posts
2 Put in post supports
3 Fill your hole up with concrete
  • Step 1. Dig holes for posts

    Mark out your holes and dig to the plans and specifications of your carport. This can be marked out with stringlines. Before you dig, make sure there isn’t any power, gas or water pipes under where you’re working.
  • Step 2. Put in post supports

    Put some timber supports over the holes for your post supports. Screw the support loosely into the timber so it’s held up out of the bottom of the hole and the concrete can go around it.
  • Step 3. Fill your hole up with concrete

    Finally, fill up your holes with the concrete. Square off the post supports while the concrete is still wet. Use your stringlines from Step 1 to make sure that your supports are all level. After the concrete dries, remove the timber supports and you’re ready to install your beams and posts.
Top of the content